Author |
Message |
   
Steve Bussey
| Posted on Thursday, September 21, 2000 - 03:30 pm: | |
Just wondering if any one has a few pictures of how they connected the wiring to the trim tab servo for the elevator? What type of wiring and connectors did you use, and how did you mount them? Steve Bussey |
   
Jerry
| Posted on Thursday, September 21, 2000 - 05:05 pm: | |
Hi Steve, I used the wire and connectors from MAC servo. Call them and ask about same. If they do not have the small connector any longer, you can get get a set of small round 5 or 6 pin connectors from Radio Shack. I will go to the store to see if I can find a part number for you. I assume you are using a MAC servo for the trim tab operation. I will also look to see if I have any pictures. Good luck. Jerry Sjostrand |
|